NXP MCX-A14X-EVK

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the NXP MCX-A14X-EVK evaluation board.
NXPX-MCX-A14X-EVK MCXA143VLH board.jpg

Preparing for J-Link

  • Connect the J-Link to J18.
  • Power the board via J8.
  • Close Jumper JP20 (disable ST-Link on SWD).
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXPX-MCX-A14X-EVK MCXA143VLH connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP MCX-A14X-EVK.
It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_MCX-A14X-EVK&oldid=17402"