NXP MCX-N5XX-EVK

This article describes specifics for the NXP X-MCX-N5XX-EVK evaluation board.
450px

Preparing for J-Link

• Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
• Power the board via J5,J27,J28 (depending on setting of J26)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

400px

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-MCX-N5XX-EVK.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.94c
• Embedded Studio: V6.34
• Hardware: NXP X-MCX-N5XX-EVK
• Link: File:NXP MCXN947 TestProject ES V634.zip