NXP iMX6SX SABRE
This article describes specifics for the NXP iMX6SX SABRE evaluation board.
Preparing for J-Link
- Connect the J-Link to JTAG connector (J17)
- Power the board via 5V power jack (J1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP iMX6SX SABRE.
The application is a simple count loop running from Flash directly.
SETUP
- J-Link software: V7.xx
- Embedded Studio: V7.20
- Hardware: NXP iMX6SX SABRE
- Link: NXP_IMX6SX_SABRE_ES_Example.zip
