Nations N32G031C8L7 STB
This article describes specifics for the Nations N32G031C8L7_STB evaluation board.
Minimum requirements
- J-Link software 7.86 or later
Preparing for J-Link
- Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
- Power the board via USB (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G031C8L7_STB N32G031C8L7.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: 7.86
- Embedded Studio: V6.34
- Hardware: N32G031C8L7_STB
- Link: File:Nations N32G031C8L7 STB N32G031C8L7 TestProject ES V634.zip