Nations N32G430C8L7-STB

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the Nations N32G430C8L7-STB evaluation board.

Nations N32G430C8L7-STB N32G430C8L7 board.jpg

Minimum requirements

  • J-Link software 7.86 or later

Preparing for J-Link

  • Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
  • Power the board via USB (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Nations N32G430C8L7-STB N32G430C8L7 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32G430C8L7-STB N32G430C8L7.
It is a simple Hello World sample linked into the internal flash.

SETUP