Nations N32L40XML-STB

This article describes specifics for the Nations N32L40XML-STB evaluation board.

Minimum requirements

• J-Link software 7.86 or later

Preparing for J-Link

• Connect the J-Link : VTref=J5-2 / GND=J5-16 / SWDIO=J5-4 / SWDCLK=J5-6
• Power the board via USB (J3 or J4)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32L40XML-STB N32L406MBL7.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: 7.86
• Embedded Studio: V6.34
• Hardware: N32L40XML-STB
• Link: File:Nations N32L40XML-STB N32L406MBL7 TestProject ES V634.zip