Nations N32WB45xL EVB

This article describes specifics for the Nations N32WB45xL_EVB evaluation board.

Minimum requirements

• J-Link software 7.86 or later

Preparing for J-Link

• Connect the J-Link : VTref=J2-2 / GND=J2-16 / SWDIO=J2-4 / SWDCLK=J2-6
• Power the board via USB (J3 or J4)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32WB45xL_EVB N32WB452LEQ6.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: 7.86
• Embedded Studio: V6.34
• Hardware: N32WB45xL_EVB
• Link: File:Nations N32WB45xL EBV N32WB452LEQ6 TestProject ES V634.zip