NuvoTon NuMaker-EVB-KM1M4B
This article describes specifics for the NuvoTon NuMaker-EVB-KM1M4B evaluation board. It can be used to test & verify NuvoTon KM1M4BF device support.
Minimum requirements
- J-Link software V7.96c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (CN5).
- Power the board via the USB jack of the break out board.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NuvoTon NuMaker-EVB-KM1M4B. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96c
- Embedded Studio: V8.10
- Hardware: NuvoTon NuMaker-EVB-KM1M4B
- Link: File:NuvoTon NuMaker-EVB-KM1M4B TestProject ES 8V10.zip