Nuvoton NuMaker-M467HJ

This article describes specifics for the Nuvoton NuMaker-M467HJ evaluation board.
600px

Preparing for J-Link

• Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
• Power the board via J2,J3 or ICE J3
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M467HJ.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.86e
• Embedded Studio: V6.34
• Hardware: Nuvoton NuMaker-M467HJ
• Link: File:Nuvoton_NuMaker-M467HJ_V1.0_M467HJHAN_TestProject_ES_V634.zip