Nuvoton NuMaker-M471R1

This article describes specifics for the Nuvoton NuMaker-M471R1 evaluation board.

Minimum requirements

• J-Link software V7.84b or later

Preparing for J-Link

• Connect the J-Link : VTref=J1-2 / GND=J1-10 / SWDIO=J1-4 / SWDCLK=J1-6
• Power the board via J2 (USB) or ICEJ3
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M263KI.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.84b
• Embedded Studio: V6.34
• Hardware: Nuvoton NuMaker-M471R1
• Link: File:Nuvoton NuMaker-M471RI M471R1E6AE TestProject ES V634.zip