Nuvoton NuMaker-NUC1262SE

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the Nuvoton NuMaker-NUC1262SE evaluation board.
File:Nuvoton NuMaker-NUC1262SE V1.2 NUC1262SE4AE board.jpg

Preparing for J-Link

  • Connect the J-Link : VTref=J1-2 / SWDIO=J1-4 / SWCLK=J1-6 / GND=J1-10
  • Power the board via J2 or ICE J3
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Nuvoton NuMaker-NUC1262SE V1.2 NUC1262SE4AE connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nuvoton NuMaker-M071MD.
It is a simple Hello World sample linked into the internal flash.

SETUP