ON Semi E8300-001-GEVB

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the ON Semiconductor Ezairo 8300 evaluation board (E8300-001-GEVB).

ONSemi E8300-001-GEVB.jpg

Minimum requirements

  • J-Link software V7.64 or later

Preparing for J-Link

  • Connect the J-Link to the "JLINK" 20 pin header
  • Power the board via micro USB cable (J5)
    Make sure htat PSU_SEL jumper is set to position 1-2
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ONSemi E8300-001-GEVB Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ON Semicondcutor E8300-000-1GEVB. It is a simple Hello World sample linked into the RAM.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=ON_Semi_E8300-001-GEVB&oldid=11650"