Renesas EK-RA6M3

This article describes specifics for the Renesas EK-RA6M3 evaluation board.

Preparing for J-Link

• Connect the J-Link to the JTAG header (J13)
• Power the board via J10.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V8.10b
• Hardware: Renesas EK-RA6M3
• Link: File:Renesas R7FA6M3AH TestProject ES V810b.zip