Renesas MCB-RA4T1

This article describes specifics for the Renesas MCB-RA4T1 evaluation board, mounting a Renesas RA4T1.

Minimum requirements

• J-Link software V7.68 or later.

Preparing for J-Link

The board comes with a J-Link OB (OnBoard debugprobe) accessible via the CN9 USB-C slot. This slot also powers the board.

• Verify the Connection with e.g. J-Link Commander.

The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas MCB-RA4T1. It is a simple Hello World sample linked into the internal program flash.

SETUP

• J-Link software: V7.68
• Embedded Studio: V6.32b
• Hardware: Renesas MCB-RA4T1
• Link: File:Renesas R7FA4T1BB TestProject.zip