Renesas MCB-RA6T3

From SEGGER Wiki
Jump to: navigation, search
Renesas MCB-RA6T3.jpg

This article describes specifics for the Renesas MCB-RA6T3 evaluation board, mounting a Renesas RA6T3.

Minimum requirements

  • J-Link software V7.68 or later.

Preparing for J-Link

The board comes with a J-Link OB (OnBoard debugprobe) accessible via the CN9 USB-C slot. This slot also powers the board.

The output should look as follows:
Renesas RA6T3 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas MCB-RA6T3. It is a simple Hello World sample linked into the internal program flash.

SETUP