ST NUCLEO-U031R8
This article describes specifics for the ST NUCLEO-U031R8 evaluation board.
Preparing for J-Link
- Power the board via CN1 (Mini)
- Reflash the ST-LINK On-Board Into a J-Link Guide
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
- Note select device: "STM32U031R8".
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-U031R8.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.97
- Embedded Studio: V8.10
- Hardware: ST NUCLEO-U031R8
- Link: File:ST NUCLEO-U031R8 TestProject ES 8V10.zip
