ST NUCLEO-U575ZI-Q

This article describes specifics for the ST NUCLEO-U575ZI-Q evaluation board.

Preparing for J-Link

• Connect the J-Link to CN5 using the 9-Pin Cortex-M Adapter.
• Power the board via CN1.
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-U575ZI-Q.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V6.74
• Embedded Studio: V4.52b
• Hardware: ST NUCLEO-U575ZI-Q
• Link: File:VENDOR DEVICENAME TestProject ES V452b.zip