ST STM32U5A9NJ
This article describes specifics for the ST STM32U5A9NJ evaluation board.
Preparing for J-Link
- Connect the J-Link to CN11.
- Power the board via CN5.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32U5A9NJ.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88j
- Embedded Studio: V6.34
- Hardware: ST STM32U5A9NJ
- Link: File:ST STM32U5A9NJ TestProject ES V634.zip
