Silicon Labs BRD4271A
This article describes specifics for the Silicon Labs BRD4271A (EFR32xG25) extension board installed on the PCB4001 carrier board evaluation board.
Preparing for J-Link
- Connect the J-Link to the 20-pin debug connector.
- Power the board using the mini USB connector.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Silicon Labs BRD4210A.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.88h
- Embedded Studio: V6.34
- Hardware: Silicon Labs BRD4210A extension board installed on the PCB4001 carrier board
- Link: File:SiliconLabs EFR32FG25BxxxF1920 TestProject ES V634.zip