TI LP-CC1311P3

This article describes specifics for the TI Launchpad CC1311P3 evaluation board.

Preparing for J-Link

• Connect the J-Link to Target In
• Unpopulate the jumpers for used debug lines: RST/TMS/TCK/TDO/TDI/SWO
• Power the board via USB
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI Launchpad CC1311P3.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.88g
• Embedded Studio: V6.34
• Hardware: TI Launchpad CC1311P3
• Link: File:TI LP-C1311P3 CC1311P3 TestProject ES V634.zip