TI LP-MSPM0L2228
This article describes specifics for the TI LP-MSPM0L2228 evaluation board. It can be used to test & verify MSPM0Lx228 device support.
Minimum requirements
- J-Link software V7.96d or later
Preparing for J-Link
- Remove SWDIO and SWCLK jumpers of J14.
- Connect the J-Link to the SWD header (XDS110).
- Power the board via the USB jack of the break out board.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the TI LP-MSPM0L2228. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96d
- Embedded Studio: V8.10
- Hardware: TI LP-MSPM0L2228
- Link: File:TI MSPM0L2228 TestProject ES 8V10.zip
