Difference between revisions of "NXP i.MX RT685 SuperMonkey"
(→SETUP) |
(→SETUP) |
||
Line 27: | Line 27: | ||
*Embedded Studio: V8.10b |
*Embedded Studio: V8.10b |
||
*Hardware: NXP i.MX RT685 SuperMonkey |
*Hardware: NXP i.MX RT685 SuperMonkey |
||
− | *Link: [[File:NXP_SuperMonkey_ES_V622.zip]] |
||
*Link: [[File:NXP_SuperMonkey_ES_V810b.zip]] |
*Link: [[File:NXP_SuperMonkey_ES_V810b.zip]] |
Revision as of 10:00, 11 June 2024
This article describes specifics for the NXP i.MX RT685 SuperMonkey evaluation board.
Minimum requirements
- J-Link software V7.65b or later
Preparing for J-Link
- Connect the J-Link to the debug connector (J3)
- Power the board via USB
Afterwards, the board should look similar to this:
Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP i.MX RT685 SuperMonkey. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.96ib
- Embedded Studio: V8.10b
- Hardware: NXP i.MX RT685 SuperMonkey
- Link: File:NXP SuperMonkey ES V810b.zip