Difference between revisions of "Infineon XMC7200 Evaluation Kit"
(→Preparing for J-Link) |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 11:30, 16 May 2024
This article describes specifics for the Infineon XMC7200 Evaluation Kit.
Preparing for J-Link
- Connect the J-Link to 10-pin MCU PROG/DEBUG connector (J16)
- Power the board via J6
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Infineon_XMC7200 Evaluation Kit.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86e
- Embedded Studio: V7.10
- Hardware: Infineon_XMC7200 Evaluation Kit
- Link: File:Infineon XMC7200 Evaluation Kit TestProject ES V710.zip