Difference between revisions of "ST NUCLEO-U575ZI-Q"
(→Preparing for J-Link) |
|||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
| − | |||
__TOC__ |
__TOC__ |
||
Latest revision as of 11:35, 15 May 2024
This article describes specifics for the ST NUCLEO-U575ZI-Q evaluation board.
Preparing for J-Link
- Connect the J-Link to CN5 using the 9-Pin Cortex-M Adapter.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST NUCLEO-U575ZI-Q.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: ST NUCLEO-U575ZI-Q
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
