Difference between revisions of "GigaDevice GD32VW553K-START"
(→Preparing for J-Link) |
|||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 14:28, 15 May 2024
This article describes specifics for the GigaDevice GD32VW553K-START evaluation board.
Preparing for J-Link
- Connect the J-Link to: VTref@J9.1 GND@J9.4 TCK@Jx. TDI@Jx. TDO@Jx. RESET@Jx. .
- Power the board via J8.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32VW553K-START.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.92l
- Embedded Studio: V6.34
- Hardware: GigaDevice GD32VW553K-START
- Link: File:GigaDevice GD32VW553H-EVAL GD32VW553H TestProject ES V634.zip
