Difference between revisions of "Renesas EK-RA6M3"
(→Preparing for J-Link) |
|||
Line 3: | Line 3: | ||
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br> |
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br> |
||
− | [[File: |
+ | [[File:Renesas_R7FA6M3AH_EK-RA6M3_picture.jpg|450px]] |
Latest revision as of 16:01, 28 June 2024
This article describes specifics for the Renesas EK-RA6M3 evaluation board.
Preparing for J-Link
- Connect the J-Link to the JTAG header (J13)
- Power the board via J10.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V8.10b
- Hardware: Renesas EK-RA6M3
- Link: File:Renesas R7FA6M3AH TestProject ES V810b.zip