Difference between revisions of "Renesas EK-RA6M3"
Line 3: | Line 3: | ||
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br> |
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br> |
||
− | [[File: |
+ | [[File:Renesas_R7FA4M2AD_EK-RA6M3_picture.jpg|450px]] |
Line 10: | Line 10: | ||
*Power the board via J10. |
*Power the board via J10. |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
− | [[File: |
+ | [[File:Renesas_R7FA4M2AD_EK-RA6M3_connect.png|400px]] |
== Example Project== |
== Example Project== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
Line 16: | Line 16: | ||
*J-Link software: V8.10b |
*J-Link software: V8.10b |
||
*Hardware: Renesas EK-RA6M3 |
*Hardware: Renesas EK-RA6M3 |
||
− | *Link: [[File: |
+ | *Link: [[File:Renesas_R7FA4M2AD_TestProject_ES_V810b.zip]] |
Revision as of 15:55, 28 June 2024
This article describes specifics for the Renesas EK-RA6M3 evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to the JTAG header (J13)
- Power the board via J10.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V8.10b
- Hardware: Renesas EK-RA6M3
- Link: File:Renesas R7FA4M2AD TestProject ES V810b.zip