Difference between revisions of "Renesas EK-RA6M3"

From SEGGER Wiki
Jump to: navigation, search
(Preparing for J-Link)
 
Line 3: Line 3:
   
 
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br>
 
This article describes specifics for the Renesas EK-RA6M3 evaluation board.<br>
[[File:Renesas_R7FA4M2AD_EK-RA6M3_picture.jpg|450px]]
+
[[File:Renesas_R7FA6M3AH_EK-RA6M3_picture.jpg|450px]]
   
   

Latest revision as of 16:01, 28 June 2024

This article describes specifics for the Renesas EK-RA6M3 evaluation board.
Renesas R7FA6M3AH EK-RA6M3 picture.jpg


Preparing for J-Link

  • Connect the J-Link to the JTAG header (J13)
  • Power the board via J10.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Renesas R7FA6M3AH EK-RA6M3 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M3.
It is a simple Hello World sample linked into the internal flash.

SETUP