Difference between revisions of "Renesas FPB-RA4E1"
(Created page with "__TOC__ This article describes specifics for the Renesas FPB-RA4E1 evaluation board. It can be used to test & verify Renesas RA4E1 support. 450px...") |
(No difference)
|
Revision as of 11:17, 19 October 2021
This article describes specifics for the Renesas FPB-RA4E1 evaluation board. It can be used to test & verify Renesas RA4E1 support.
Minimum requirements
- J-Link software V7.58 or later
Preparing for J-Link
- Attach the board over the debug USB-port to your PC (J9 - J-Link OB). This will power the board as well.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-RA4E1. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.58
- Embedded Studio:
- Hardware: Renesas FPB-RA4E1
- Link: File:TestAPP ProgFlash RA4E1.zip