Difference between revisions of "MindMotion Mini-F0040"
(Created page with "__TOC__ This article describes specifics for the [MindMotion] [Mini-F0040] evaluation board.<br> '''[PICTURE OF BOARD]''' 450px == Preparing fo...") |
|||
| Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
| − | This article describes specifics for the |
+ | This article describes specifics for the MindMotion Mini-F0040 evaluation board.<br> |
'''[PICTURE OF BOARD]''' |
'''[PICTURE OF BOARD]''' |
||
| − | [[File: |
+ | [[File:MindMotion_Mini-F0040_MM32F0040B1T_board.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
| − | *Connect the J-Link to |
+ | *Connect the J-Link to CN2. |
| − | *Power the board via |
+ | *Power the board via CN1. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
'''[PICTURE OF CONNECT]''' |
'''[PICTURE OF CONNECT]''' |
||
Revision as of 15:53, 24 March 2023
This article describes specifics for the MindMotion Mini-F0040 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
[PICTURE OF CONNECT]
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the [SiliconVendor] [EvalBoardName].
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: [SiliconVendor] [EvalBoardName]
- Link: File:VENDOR DEVICENAME TestProject ES V452b.zip
