Difference between revisions of "Renesas MCB-RA4T1"
(Created page with "450px|thumb|right This article describes specifics for the Renesas MCB-RA4T1 evaluation board. __TOC__ <br clear="all"> == Minimum requirements...") |
(No difference)
|
Revision as of 12:12, 27 April 2023
This article describes specifics for the Renesas MCB-RA4T1 evaluation board.
Minimum requirements
- J-Link software V7.68 or later.
Preparing for J-Link
The board comes with a J-Link OB (OnBoard debugprobe) accessible via the CN9 USB-C slot. This slot also powers the board.
- Verify the Connection with e.g. J-Link Commander.
The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas MCB-RA4T1. It is a simple Hello World sample linked into the internal program flash.
SETUP
- J-Link software: V7.68
- Embedded Studio: V6.32b
- Hardware: Renesas MCB-RA4T1
- Link: File:Renesas R7FA4T1BB TestProject.zip
