Difference between revisions of "Infineon PMG1"
(→Connect) |
(→Internal Flash) |
||
Line 10: | Line 10: | ||
|- |
|- |
||
| PMG1-B1 || Internal Flash || 0x00000000 || 128 KB || style="text-align:center;"| {{YES}} |
| PMG1-B1 || Internal Flash || 0x00000000 || 128 KB || style="text-align:center;"| {{YES}} |
||
+ | |- |
||
+ | | PMG1-S0 || Internal Flash || 0x00000000 || 64 KB || style="text-align:center;"| {{YES}} |
||
|} |
|} |
||
Revision as of 11:54, 13 May 2024
The Infineon PMG1 is a family of high-voltage USB PD MCUs with Arm® Cortex®-M0/Cortex-M0+ CPU.
Contents
Flash Banks
Internal Flash
Subfamily | Flash Bank | Base address | Size | J-Link Support |
---|---|---|---|---|
PMG1-B1 | Internal Flash | 0x00000000 | 128 KB | |
PMG1-S0 | Internal Flash | 0x00000000 | 64 KB |
Watchdog Handling
- The device has a watchdog WDT.
- The watchdog is not fed during flash programming.
Device Specific Handling
Connect
The connect sequence of PMG1 devices is very time critical and is performed from the J-Link's side directly in either one of these 2 modes:
- Reset mode:
J-Link toggles the XRES line and then sends SWD commands.
Reset mode is not supported by PMG1-S0 devices because they do not have an XRES pin.
- Power Cycle mode:
J-Link powers on the target and then starts sending the SWD commands.
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.
Make sure to set VSupply (pin 19) correctly before connecting it to the target board.
This is the only mode supported by PMG1-S0 devices.
Reset
- The device uses custom reset via AIRCR.SYSRESETREQ and halt at application entry point.
Limitations
Attach
Attach is not supported because the J-Link resets the device on connect.