Difference between revisions of "Infineon PMG1"

From SEGGER Wiki
Jump to: navigation, search
(Internal Flash)
(Device Specific Handling)
Line 29: Line 29:
 
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.<br>
 
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.<br>
 
Make sure to set VSupply (pin 19) correctly before connecting it to the target board. <br>
 
Make sure to set VSupply (pin 19) correctly before connecting it to the target board. <br>
This is the only mode supported by PMG1-S0 devices.
+
This is the only mode supported by PMG1-S0 devices.<br>
  +
<br>
  +
A device with reconfigured SWD pins runs automatically the acquire sequence to get control of the SWD pins for debugging back.<br>
   
 
===Reset===
 
===Reset===

Revision as of 11:59, 13 May 2024

The Infineon PMG1 is a family of high-voltage USB PD MCUs with Arm® Cortex®-M0/Cortex-M0+ CPU.

Flash Banks

Internal Flash

Subfamily Flash Bank Base address Size J-Link Support
PMG1-B1 Internal Flash 0x00000000 128 KB YES.png
PMG1-S0 Internal Flash 0x00000000 64 KB YES.png

Watchdog Handling

  • The device has a watchdog WDT.
  • The watchdog is not fed during flash programming.

Device Specific Handling

Connect

The connect sequence of PMG1 devices is very time critical and is performed from the J-Link's side directly in either one of these 2 modes:

  • Reset mode:

J-Link toggles the XRES line and then sends SWD commands.
Reset mode is not supported by PMG1-S0 devices because they do not have an XRES pin.

  • Power Cycle mode:

J-Link powers on the target and then starts sending the SWD commands.
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.
Make sure to set VSupply (pin 19) correctly before connecting it to the target board.
This is the only mode supported by PMG1-S0 devices.

A device with reconfigured SWD pins runs automatically the acquire sequence to get control of the SWD pins for debugging back.

Reset

  • The device uses custom reset via AIRCR.SYSRESETREQ and halt at application entry point.

Limitations

Attach

Attach is not supported because the J-Link resets the device on connect.

Evaluation Boards

Example Application