Difference between revisions of "NXP MCX-N5XX-EVK"
(Created page with "__TOC__ This article describes specifics for the NXP X-MCX-N5XX-EVK evaluation board.<br> 450px == Preparing for J-Link == *Connect the...") |
|||
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 13: | Line 14: | ||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-MCX-N5XX-EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-MCX-N5XX-EVK.<br>It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
− | *J-Link software: V7. |
+ | *J-Link software: V7.94c |
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: NXP X-MCX-N5XX-EVK |
*Hardware: NXP X-MCX-N5XX-EVK |
Latest revision as of 13:19, 15 May 2024
This article describes specifics for the NXP X-MCX-N5XX-EVK evaluation board.
450px
Preparing for J-Link
- Connect the J-Link to J11, J6 hast to set in order to disable MCU-Link on the PCB and work with J-Link.
- Power the board via J5,J27,J28 (depending on setting of J26)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP X-MCX-N5XX-EVK.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.94c
- Embedded Studio: V6.34
- Hardware: NXP X-MCX-N5XX-EVK
- Link: File:NXP MCXN947 TestProject ES V634.zip