Difference between revisions of "Infineon WLC"
(→Connect) |
(→Evaluation Boards) |
||
| Line 35: | Line 35: | ||
==Evaluation Boards== |
==Evaluation Boards== |
||
| + | *[[Infineon_REF_WLC_TX15W_C1| WLC_TX15W_C1]] |
||
| − | *[[Infineon_EVAL_PMG1_B1_DRP| EVAL_PMG1_B1_DRP]] |
||
| − | *[[Infineon_CY7110EZ-PD_PMG1-S0_Prototyping_kit | CY7110EZ-PD PMG1-S0 Prototyping kit]] |
||
| − | *[[Infineon_CY7110EZ-PD_PMG1-S1_Prototyping_kit | CY7110EZ-PD PMG1-S1 Prototyping kit]] |
||
| − | *[[Infineon_CY7110EZ-PD_PMG1-S2_Prototyping_kit | CY7110EZ-PD PMG1-S2 Prototyping kit]] |
||
| − | |||
==Example Application== |
==Example Application== |
||
Revision as of 10:32, 30 May 2024
The Infineon WLC is a family of wireless charging transmitter IC MCUs with Arm® Cortex®-M0 CPU.
Contents
Flash Banks
Internal Flash
| Flash Bank | Base address | Size | J-Link Support |
|---|---|---|---|
| Internal Flash | 0x00000000 | 128 KB | 
|
Watchdog Handling
- The device has a watchdog WDT.
- The watchdog is not fed during flash programming.
Device Specific Handling
Connect
The connect sequence WLC devices is very time critical and is performed from the J-Link's side directly in either one of these 2 modes:
- Reset mode:
J-Link toggles the XRES line and then sends SWD commands.
- Power Cycle mode:
J-Link powers on the target and then starts sending the SWD commands.
Therefore the target device needs to be supplied via Pin 19 of the J-Link and Pin 1 also needs to be connected to pin 19 of the J-Link.
Make sure to set VSupply (pin 19) correctly before connecting it to the target board.
A device with reconfigured SWD pins runs automatically the acquire sequence to get control of the SWD pins for debugging back.
Reset
- The device uses custom reset via AIRCR.SYSRESETREQ and halt at application entry point.
Limitations
Attach
Attach is not supported because the J-Link resets the device on connect.
