Difference between revisions of "IndieSemi Realplum-EVK"
(Created page with "__TOC__ This article describes specifics for the IndieSemi Realplum EVK. TBD 450px == Minimum requirements == *J-Link software V6.84 or later...") |
(→Example Project) |
||
Line 18: | Line 18: | ||
== Example Project== |
== Example Project== |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the IndieSemi Realplum. It is a simple Hello World sample linked into the internal flash. |
'''SETUP''' |
'''SETUP''' |
||
− | *J-Link software: V6. |
+ | *J-Link software: >= V6.83d |
− | *Embedded Studio: V4.52b |
+ | *Embedded Studio: >= V4.52b |
+ | *Hardware: IndieSemi Realplum EVK |
||
− | *Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
||
− | *Link: [[File: |
+ | *Link: [[File:IndieSemi_Realplum_TestProject_ES_V452b.zip]] |
Revision as of 14:58, 19 August 2020
This article describes specifics for the IndieSemi Realplum EVK.
Minimum requirements
- J-Link software V6.84 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Connect the J-Link to the SWD header (P1)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the IndieSemi Realplum. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: >= V6.83d
- Embedded Studio: >= V4.52b
- Hardware: IndieSemi Realplum EVK
- Link: File:IndieSemi Realplum TestProject ES V452b.zip