Difference between revisions of "NXP FRDM-KV31F"
(Created page with "__TOC__ This article describes specifics for the NXP FRDM-KV31F evaluation board. The board supports different Upgrade boards. 500px == Minimum requ...") |
|||
(3 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Line 20: | Line 21: | ||
[[File:KV31F J-LinkCLI.png|500px]] |
[[File:KV31F J-LinkCLI.png|500px]] |
||
+ | |||
+ | == Sample Project == |
||
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-KV31F. It is a simple Hello World sample linked into the internal flash. |
||
+ | ===SETUP=== |
||
+ | *J-Link software: V7.58 |
||
+ | *Embedded Studio: V5.68 |
||
+ | *Hardware: NXP FRDM-KV31F |
||
+ | *Link: [[File:NXP_FRDM-KV31F_TestProject_ES_V568.zip]] |
Latest revision as of 15:23, 8 May 2024
Contents
This article describes specifics for the NXP FRDM-KV31F evaluation board. The board supports different Upgrade boards.
Minimum requirements
- J-Link software V4.82 or later
Special characteristics
NXP delivers this board with already changed XACCH0 value (0x7F). XACCH0[63] protects flash address 0x0007_E000 - 0x0007_FFFF from writing. Therefore erase / program of flash >= 0x0007_E000 is not possible. Any attempt to do this will result in: "Failed to erase sectors 252 @ address 0x0007E000 (Algo35: Flash protection violation. Flash is write-protected.)". This behavior is expected and influences not the first block.
Preparing for J-Link
- Connect the J-Link to the SWD header (J9)
- Power the board via USB (J6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Sample Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-KV31F. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.58
- Embedded Studio: V5.68
- Hardware: NXP FRDM-KV31F
- Link: File:NXP FRDM-KV31F TestProject ES V568.zip