Difference between revisions of "Nations N32WB45xL EVB"
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
Latest revision as of 15:37, 8 May 2024
This article describes specifics for the Nations N32WB45xL_EVB evaluation board.
Minimum requirements
- J-Link software 7.86 or later
Preparing for J-Link
- Connect the J-Link : VTref=J2-2 / GND=J2-16 / SWDIO=J2-4 / SWDCLK=J2-6
- Power the board via USB (J3 or J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Nations N32WB45xL_EVB N32WB452LEQ6.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: 7.86
- Embedded Studio: V6.34
- Hardware: N32WB45xL_EVB
- Link: File:Nations N32WB45xL EBV N32WB452LEQ6 TestProject ES V634.zip