Difference between revisions of "STM32H7B3I-EVAL"
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the ST STM32H7B3I-EVAL evaluation board.<br> |
This article describes specifics for the ST STM32H7B3I-EVAL evaluation board.<br> |
||
− | [[File: |
+ | [[File:STM32H7B3I-EVAL.jpg|450px]] |
== Preparing for J-Link == |
== Preparing for J-Link == |
Latest revision as of 15:24, 8 May 2024
This article describes specifics for the ST STM32H7B3I-EVAL evaluation board.
Preparing for J-Link
- Connect the J-Link to the 20-pin JTAG debug connector (CN14)
- Power the board via the 5V DC power jack (CN17)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H7B3I-EVAL.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86d
- Embedded Studio: V7.10
- Hardware: ST STM32H7B3I-EVAL
- Link: File:ST STM32H7B3I-EVAL TestProject ES V710.zip