Difference between revisions of "MindMotion Mini-F0040"
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 17: | Line 18: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: MindMotion Mini-F0040 |
*Hardware: MindMotion Mini-F0040 |
||
| − | *Link: [[File: |
+ | *Link: [[File:MindMotion_Mini-F0040_MM32F0040B1T_TestProject_ES_6V34.zip]] |
Latest revision as of 15:11, 15 May 2024
This article describes specifics for the MindMotion Mini-F0040 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to CN2.
- Power the board via CN1.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-F0040.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86f
- Embedded Studio: V6.34
- Hardware: MindMotion Mini-F0040
- Link: File:MindMotion Mini-F0040 MM32F0040B1T TestProject ES 6V34.zip
