Difference between revisions of "GigaDevice GD32E507Z-EVAL"
(Created page with "__TOC__ This article describes specifics for the GigaDevice GD32E507Z-EVAL evaluation board. 450px == Minimum requirements == * J-Link sof...") |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
| Line 6: | Line 7: | ||
== Minimum requirements == |
== Minimum requirements == |
||
| − | * J-Link software V6. |
+ | * J-Link software V6.87b or later |
== Preparing for J-Link == |
== Preparing for J-Link == |
||
Latest revision as of 15:17, 8 May 2024
This article describes specifics for the GigaDevice GD32E507Z-EVAL evaluation board.
Minimum requirements
- J-Link software V6.87b or later
Preparing for J-Link
The GD32E507Z-EVAL does come with a JTAG connector. You only have to connect it to your J-Link and power it via the USB port (CN 100). The result should be looking like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E507Z-EVAL. It is a simple blinky application which toggles LED1. The application is linked into the internal flash.
SETUP
- J-Link software: V6.87b
- Embedded Studio: V4.52b (or later)
- Hardware: GigaDevice GD32E507Z-EVAL
- Link: File:GigaDevice GD32E507Z TestProject ES V452b.zip
