Telink TLSR9518ADK80D

Telink TLSR9518ADK80D evaluation board (TLSR9518 series)

The Telink TLSR9518ADK80D is a Telink TLSR9518 evaluation board.

Features (selection)

• RISC-V 32Bit MCU
• 2MB on board QSPI flash
• Micro USB-B 1.1
• Line-In
• On board LED
• external debug connector pins

For further information please refer to the Telink TLSR9 wiki page

Setting up with J-Link

Telink TLSR9518 series debug interface connection front

Telink TLSR9518 series debug interface connection rear

The Telink TLSR9518ADK80D evaluation board comes with an external JTAG debug connector (6 pins: TDI, TDO, TCK, TMS, GND, VBUS). To set the board up with J-Link, the following steps are required:

1. Connect the J-Link to the evaluation board, using jumper wires as follows at connector J56:

   Pin RP Pico	Pin J-Link	Signal
   "TL PE4 TDI"	5	TDI
   "TL PE5 TDO"	13	TDO
   "TL PE7 TCK"	9	TCK
   "TL PE6 TMS"	7	TMS
   "DEBUG" "GND"	4	GND
   "VBUS"	1	VTref

Note: For a more reliable, simpler solution, the SEGGER Flying Wire Adapter is recommended.

Example Projects

TBD