Difference between revisions of "Renesas RZ/N2L-RSK"
Line 2: | Line 2: | ||
This article describes specifics for the Renesas RZ/N2L-RSK evaluation board. |
This article describes specifics for the Renesas RZ/N2L-RSK evaluation board. |
||
− | |||
<!-- [[File:Renesas_RZN2L-RSK.jpg|450px]] --> |
<!-- [[File:Renesas_RZN2L-RSK.jpg|450px]] --> |
||
− | |||
== Minimum requirements == |
== Minimum requirements == |
||
* J-Link software V7.70a or later |
* J-Link software V7.70a or later |
Revision as of 15:06, 10 August 2022
This article describes specifics for the Renesas RZ/N2L-RSK evaluation board.
Minimum requirements
- J-Link software V7.70a or later
Preparing for J-Link
- Connect the J-Link to the debug header (J13 or J20)
- Power the board via USB C (CN5) or external power supply / power jack (CN6)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
TBD
SETUP
TBD