Difference between revisions of "QSPI Flash Programming Support"
(→Customized Solution Required) |
(→Solution) |
||
Line 6: | Line 6: | ||
== Solution == |
== Solution == |
||
− | For any supported QSPI Controller we create 1-2 example flash |
+ | For any supported QSPI Controller we create 1-2 example flash loader based on the pin configuration of the evaluation board. If you chose the same pin layout as used on the evaluation board, the flash algorithms can be used out-of-the-box. |
== Customized Solution Required == |
== Customized Solution Required == |
Revision as of 13:03, 15 November 2022
Contents
General Information
More and more CPUs include an so called SPIFI memory controller which allows memory mapped read accesses to any SPI flash, connected to the Quad-SPI interface of the CPU. This allows the J-Link DLL to support flash programming through the Quad-SPI interface of the CPU.
Problem
Some CPUs allow to use different port / pin configurations for the connection of the SPI flash. Thus, for each possible pin / port configuration a slightly different flash algorithm is required, even if the same SPI flash and the same CPU is used.
Solution
For any supported QSPI Controller we create 1-2 example flash loader based on the pin configuration of the evaluation board. If you chose the same pin layout as used on the evaluation board, the flash algorithms can be used out-of-the-box.
Customized Solution Required
If the pin configuration differs from the one listed on the wiki page of the device, you will need a custom flash loader. There are three options for the development of a custom flash loader:
- You may add a custom flash loader yourself with the SEGGER Device Support Kit (DSK).
- You develop a custom flash loader with the help of the existing flash loaders' source code.
- SEGGER develops the custom flash loader for you.
If you are interested in any of those options, please contact info@segger.com.
Specific Landing Pages Provide Following Information
- Setup (CPU / board)
- Port / pin configuration
- JLinkDevices.XML
- Files