Difference between revisions of "Analog Devices EV-ADuCM340ARDZ"
(Created page with "__TOC__ This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.<br> 450px == Preparing for J-Link...") |
|||
Line 1: | Line 1: | ||
+ | [[Category:Evalboards]] |
||
__TOC__ |
__TOC__ |
||
This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.<br> |
This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.<br> |
Latest revision as of 15:12, 8 May 2024
This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.
Preparing for J-Link
- Connect the J-Link via P11 to the target board
- Power the board via P34 (5V center positive)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-ADuCM430ARDZ.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86
- Embedded Studio: V6.34a
- Hardware: Analog Devices EV-ADuCM340ARDZ
- Link: File:AnalogDevices ADuCM340 TestProject ES 634a.zip