Difference between revisions of "MindMotion Mini-F0163"
Line 6: | Line 6: | ||
== Preparing for J-Link == |
== Preparing for J-Link == |
||
− | *Connect the J-Link to |
+ | *Connect the J-Link to CN5. |
− | *Power the board via |
+ | *Power the board via CN2 or CN3. |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
[[File:MindMotion_Mini-F0163_MM32F0163D7PV_connect.png|400px]] |
[[File:MindMotion_Mini-F0163_MM32F0163D7PV_connect.png|400px]] |
Revision as of 07:05, 27 March 2023
This article describes specifics for the MindMotion Mini-F0163 evaluation board.
[PICTURE OF BOARD]
450px
Preparing for J-Link
- Connect the J-Link to CN5.
- Power the board via CN2 or CN3.
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the MindMotion Mini-F0163.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.86f
- Embedded Studio: V6.34
- Hardware: MindMotion Mini-F0163
- Link: File:MindMotion Mini-F0163 MM32F0163D7PV TestProject ES 6V34.zip