Difference between revisions of "Microchip PIC32CM Lx"
Line 1: | Line 1: | ||
. |
. |
||
− | The '''Microchip PIC32MC Lx''' are Robust Security, Ultra-Low Power and Enhanced Touch Microcontrollers Based on Arm® Cortex®- |
+ | The '''Microchip PIC32MC Lx''' are Robust Security, Ultra-Low Power and Enhanced Touch Microcontrollers Based on Arm® Cortex®-M23 Core. |
__TOC__ |
__TOC__ |
||
Line 9: | Line 9: | ||
! Flash Bank || Base address !! Size || J-Link Support |
! Flash Bank || Base address !! Size || J-Link Support |
||
|- |
|- |
||
− | | |
+ | | Internal Flash || 0x00000000 || 256/512 KB || style="text-align:center;"| {{YES}} |
+ | |- |
||
+ | | Data Flash || 0x00400000 || 8/16 KB || style="text-align:center;"| {{YES}} |
||
+ | |- |
||
+ | | User Row || 0x00804000 || 36 B || style="text-align:center;"| {{YES}} |
||
+ | |- |
||
+ | | BOCOR || 0x0080C000|| 8/32/48 B || style="text-align:center;"| {{YES}} |
||
|} |
|} |
||
+ | |||
====ECC Flash [OPTIONAL]==== |
====ECC Flash [OPTIONAL]==== |
Revision as of 07:17, 2 May 2023
. The Microchip PIC32MC Lx are Robust Security, Ultra-Low Power and Enhanced Touch Microcontrollers Based on Arm® Cortex®-M23 Core.
Contents
Flash Banks
Internal Flash
Flash Bank | Base address | Size | J-Link Support |
---|---|---|---|
Internal Flash | 0x00000000 | 256/512 KB | |
Data Flash | 0x00400000 | 8/16 KB | |
User Row | 0x00804000 | 36 B | |
BOCOR | 0x0080C000 | 8/32/48 B |
ECC Flash [OPTIONAL]
- Describe ECC Flash restriction here.
QSPI Flash
QSPI flash programming requires special handling compared to internal flash. For more information about this, please see the QSPI Flash Programming Support article.
J-Link supports multiple pin configurations for [DEVICE]. The default loader is marked in bold.
Device | Base address | Maximum size | Supported pin configuration |
---|---|---|---|
[DEVICE] | [BANK_BASE_ADDRESS] | [MAX_SPI_FLASH_SIZE] MB |
|
ECC RAM [OPTIONAL]
- Describe ECC RAM restriction here.
Vector Table Remap [OPTIONAL]
- Describe Vector Table Remap here..
Watchdog Handling
- The device does not have a watchdog.
- The device has a watchdog [WATCHDOGNAME].
- The watchdog is fed during flash programming.
- If the watchdog is enabled, it is turned off during flash programming and turned back on afterwards.
Multi-Core Support [OPTIONAL]
Before proceeding with this article, please check out the generic article regarding Multi-Core debugging here.
The [DeviceFamily]family comes with a variety of multi-core options.
Some devices from this family feature a secondary core which is disabled after reset / by default.
Some of the are available with enabled lockstep mode, only.
In below, the debug related multi-core behavior of the J-Link is described for each core:
Main core
Init/Setup
- Initializes the ECC RAM, see XXX
- Enables debugging
Reset
- Device specific reset is performed, see XXX
Attach
- Attach is not supported because the J-Link initializes certain RAM regions by default
Secondary core(s)
Init/Setup
- If the main core session has not been started / debugging is not enabled yet, the secondary core executes the enable debug sequence.
- If the secondary core is not enabled yet, it will be enabled / release from reset
Reset
No reset is performed.
Attach
- Attach is supported / desired
Device Specific Handling
Reset
- The devices uses normal Cortex-M reset, no special handling necessary, like described here.
- The devices uses Cortex-M Core reset, no special handling necessary, like described here.
- The devices uses Cortex-M Rest Pin, no special handling necessary, like described here.
- The device uses custom reset:.....
Limitations
Dual Core Support
Some XXX devices feature a second core. Right now, the J-Link software does support the main core, only. Support for the second core is planned for future versions.
Attach
Attach is not supported by default because the J-Link initializes certain RAM regions by default.
Evaluation Boards
- [SiliconVendor] [EvalBoardName] evaluation board: http://techwiki.segger.local/WikiTemplateEvalBoard
Example Application
- [SiliconVendor] [EvalBoardName] evaluation board: http://techwiki.segger.local/WikiTemplateEvalBoard#Example_Project