Difference between revisions of "Kinetis KE1xZ 48 MHz series"
Line 4: | Line 4: | ||
= J-Link support = |
= J-Link support = |
||
− | The KE14Z32, KE14Z64, KE15Z32, KE15Z64, KE16Z32, KE16Z64 are supported |
+ | The KE14Z32, KE14Z64, KE15Z32, KE15Z64, KE16Z32, KE16Z64 are supported since the following J-Link software versions: |
+ | * V6.35g (beta) or later ([https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPackBeta Download latest beta]) |
||
− | |||
− | [https://www.segger.com/downloads/jlink/#J- |
+ | * V6.36 (release) or later ([https://www.segger.com/downloads/jlink/#J-LinkSoftwareAndDocumentationPack Download latest release]) |
= Watchdog support = |
= Watchdog support = |
Revision as of 11:50, 25 September 2018
The NXP Kinetis KE1xZ 48 MHz series is deigned for white goods and industrial applications. It incorporates an ARM Cortex-M0+ core.
J-Link support
The KE14Z32, KE14Z64, KE15Z32, KE15Z64, KE16Z32, KE16Z64 are supported since the following J-Link software versions:
- V6.35g (beta) or later (Download latest beta)
- V6.36 (release) or later (Download latest release)
Watchdog support
Debugging and flash programming with the watchdog (WDOG) being enabled (in non-windowed mode) is supported. Windowed mode of the watchdog is not supported for debugging and flash programming.
MTB trace
The KE1xZ 48 MHz series devices incorporate an ARM MTB on-chip trace buffer that allows instruction backtrace. For more information about MTB in general, please refer to here: Article MTB.
Example projects
TBD
Requirements
The following are the min. requirements to run the example project:
- SEGGER Embedded Studio Vxxx or later
- J-Link software V6.35g or later. (Install after Embedded Studio and let J-Link installer update the Embedded Studio installation)
- xxx board