Difference between revisions of "Tracing on ST STM32F769"
(Created page with "__TOC__ This article describes how to get started with trace on the ST STM32F769 MCU. This article assumes that there is already a basic knowledge about trace in general (wha...") |
(→Streaming trace) |
||
Line 13: | Line 13: | ||
== Streaming trace == |
== Streaming trace == |
||
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ST STM32F769I-EVALBOARD. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ST STM32F769I-EVALBOARD. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, [https://www.segger.com/embedded-studio.html SEGGER Embedded Studio] can be used. |
||
+ | |||
+ | [[:File:ST_STM32F769I-EVAL_16MHz.zip | ST_STM32F769I-EVAL_16MHz.zip]] |
Revision as of 14:52, 16 February 2017
This article describes how to get started with trace on the ST STM32F769 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The ST STM32F769 MCU implements tracing via pins , so a J-Trace can be used for tracing.
Minimum requirements
In order to use trace on the ST STM32F769 MCU devices, the following minimum requirements have to be met:
- J-Link software version V6.13e (beta) or later
- Ozone V2.22o or later (if streaming trace and / or the sample project from below shall be used)
- J-Trace PRO for Cortex-M HW version V1.0 or later
Sample project
Streaming trace
The following sample project is designed to be used with J-Trace PRO and Ozone to demonstrate streaming trace. The project has been tested with the minimum requirements mentioned above and a ST STM32F769I-EVALBOARD. The sample project comes with a pre-configured project file for Ozone that runs out-of-the box. In order to rebuild the sample project, SEGGER Embedded Studio can be used.