Difference between revisions of "NXP JN5189-DK006"
(→Example Project) |
(→Example Project) |
||
Line 18: | Line 18: | ||
== Example Project== |
== Example Project== |
||
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.<br> |
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.<br> |
||
− | + | ====SETUP==== |
|
*J-Link software: V6.74 |
*J-Link software: V6.74 |
||
*Embedded Studio: V4.52b |
*Embedded Studio: V4.52b |
Revision as of 11:32, 31 May 2021
This article describes specifics for the NXP JN5189-DK006 evaluation board. The board supports different Upgrade boards. It can be used to test & verify QN9090 and JN5189 support.
Minimum requirements
- J-Link software V6.74 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Connect the J-Link to the SWD header (P1)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V6.74
- Embedded Studio: V4.52b
- Hardware: NXP JN5189-DK006 (QN9090 upgrade board)
- Link: File:NXP QN9090 TestProject ES V452b.zip